Augmented Reality at Your Fingertips
May 1, 2017 | KAUSTEstimated reading time: 2 minutes
A flexible, carbon-based device that responds to humidity in two ways can sense 3D objects without touching them. The intuitive touch screens integral to smartphones caused a sensation when first released, and they remain popular for many consumer electronics. Now, a team from KAUST has found a way to take these input devices into three dimensions with a sensor that tracks the position and speed of human fingers in free space.
Thin films made from carbon nanotubes or graphene oxides have electrical properties that are highly sensitive to humidity. Both substances absorb water molecules and transform them into charged hydronium ions (H3O+) that modify thin film conductivity in reversible, repeatable ways. They do this at faster speeds than traditional humidity sensors. The direction of conductivity change, however, depends on the nanomaterial—graphene oxide tends toward higher conductivity with H3O+additions, while nanotubes become more resistive.
Dr. Yanlong Tai and Professor Gilles Lubineau realized that a combination of these tiny nanomaterials could be used to power a recognition system based on gestures rather than touch. “These 3D non-contact sensors,” explained Tai, “require generation of three different signals during a one-time measurement.” The duo envisioned that an appropriate mix of nanotubes and graphene oxides would give triple response patterns—positive-negative-negative, for example, to the natural humidity surrounding a fingertip.
However, to achieve sufficient signal resolution to process a finger’s 3D position, they needed clearer insight into the contradictory response of nanotubes and graphene oxide to humidity. According to Lubineau, absorbed H3O+ ions induce mechanical stress inside the nanomaterials that alters the material’s bulk conductivity and the junction conductivity between individual nanoparticles.
“Both films rely on the same two mechanisms, but the balance between them is totally different,” said Lubineau. “A key challenge was to be able to correctly separate the physics of each effect in the different microstructures.”
By experimenting with sensors containing different microstructure layouts, the team deduced that a net model, where conductivity follows a grid-like system of intercrossed pathways, could explain the humidity-induced resistance of nanotube films. Graphene oxide, on the other hand, was best represented by an overlapping scale design that introduced favorable capacitive effects in the presence of H3O+.
The researchers used this knowledge to fabricate a flexible, transparent device that measures the distance, speed and direction of a fingertip placed above it. This prototype also worked with vapor from human breath, and it is poised to make gesture sensing a part of digital input interfaces.
“It’s usually hard to make non-contact sensors operate with different moisture levels,” said Lubineau. “Our findings here may promote their use in augmented reality setups.”
Suggested Items
SIA Statement on Senate Commerce Committee Legislation that Funds CHIPS & Science Programs
05/02/2024 | SIAThe Semiconductor Industry Association (SIA) today released the following statement from Vice President of Government Affairs David Isaacs in support of provisions included in legislation pending before the Senate Commerce Committee that would fund critical CHIPS & Science Act programs.
Intel Takes Next Step Toward Building Scalable Silicon-Based Quantum Processors
05/02/2024 | BUSINESS WIRENature published an Intel research paper, “Probing single electrons across 300-mm spin qubit wafers,” demonstrating state-of-the-art uniformity, fidelity and measurement statistics of spin qubits.
IPC's Vision for Empowering PCB Design Engineers
04/30/2024 | Robert Erickson, IPCAs architects of innovation, printed circuit board designers are tasked with translating increasingly complex concepts into tangible designs that power our modern world. IPC provides the necessary community, standards framework, and education to prepare these pioneers as they explore the boundaries of what’s possible, equipping engineers with the knowledge, skills, and resources required to thrive in an increasingly dynamic field.
Incap US Hosts Annual Food Drive
04/30/2024 | IncapIncap US recently concluded its annual food drive, a tradition aimed at supporting the Greater Washington County Food Bank. This year marked the fourth year of the initiative, and we couldn’t be prouder of the collective effort that was made to its success.
Guerrilla RF Completes Strategic Acquisition of GaN Device Portfolio from Gallium Semiconductor
04/29/2024 | BUSINESS WIREGuerrilla RF, Inc. has finalized the acquisition of Gallium Semiconductor's entire portfolio of GaN power amplifiers and front-end modules. Effective April 26th, 2024, GUER acquired all previously released components as well as new cores under development at Gallium Semiconductor.