Engineered Material Systems to Exhibit at Intersolar North America
July 6, 2016 | Engineered Material Systems, Inc.Estimated reading time: 1 minute
Engineered Material Systems, Inc. (EMS), a leading global supplier of conductive interconnect materials for photovoltaic applications, will exhibit its new 561-400 series Low-Cost Snap Cure Conductive Adhesives at Intersolar North America, scheduled to take place July 12-14 in San Francisco, CA. The 561-400 series is designed for stringing and shingling crystalline silicon and heterojunction solar modules.
The EMS 561-400 series is designed to be used in modified ribbon stringers. The material will snap cure and fixture ribbons in seconds at 150°C with enough strength to withstand module manufacturing processes until the adhesive cure is completed during the encapsulant lamination process. EMS 561-400 series conductive adhesives can be dispensed by time-pressure, auger or jetting.
The adhesive is more stress absorbing than solder to withstand the rigors of thermal cycling and processes at lower temperatures than solder. EMS 561-400 series conductive adhesives are 60 percent less expensive than pure silver-filled conductive adhesives.
For more information about EMS’ low cost conductive adhesives or to learn how the company can define, develop and create an engineered material solution that is right for your company, meet with company representatives in Booth #7738 at Intersolar North America.
About Engineered Material Systems
Engineered Materials Systems, Inc. (EMS) technology focus is on electronic materials for semiconductor, circuit assembly, photovoltaic, printer head, camera module, disk drive and photonics assembly product lines. The company creates continual improvements that will guide its customers into the future.
Suggested Items
Taiyo Circuit Automation Installs New DP3500 into Fuba Printed Circuits, Tunisia
04/25/2024 | Taiyo Circuit AutomationTaiyo Circuit Automation is proud to be partnered with Fuba Printed Circuits, Tunisia part of the OneTech Group of companies, a leading printed circuit board manufacturer based out of Bizerte, Tunisia, on their first installation of Taiyo Circuit Automation DP3500 coater.
Vicor Power Orders Hentec Industries/RPS Automation Pulsar Solderability Testing System
04/24/2024 | Hentec Industries/RPS AutomationHentec Industries/RPS Automation, a leading manufacturer of selective soldering, lead tinning and solderability test equipment, is pleased to announce that Vicor Power has finalized the purchase of a Pulsar solderability testing system.
AIM Solder’s Dillon Zhu to Present on Ultraminiature Soldering at SMTA China East
04/22/2024 | AIMAIM Solder, a leading global manufacturer of solder assembly materials for the electronics industry, is pleased to announce that Dillon Zhu will present on the topic: Ultraminiature Soldering: Techniques, Technologies, and Standards at SMTA China East. This event is being held at the Shanghai World Expo Exhibition & Convention Center from April 24-25.
AIM to Highlight NC259FPA Ultrafine No Clean Solder Paste at SMTA Wisconsin Expo & Tech Forum
04/18/2024 | AIMAIM Solder, a leading global manufacturer of solder assembly materials for the electronics industry, is pleased to announce its participation in the upcoming SMTA Wisconsin Expo & Tech Forum taking place on May 7 at the Four Points by Sheraton | Milwaukee Airport, in Milwaukee, Wisconsin.
Hentec/RPS Publishes an Essential Guide to Selective Soldering Processing Tech Paper
04/17/2024 | Hentec Industries/RPS AutomationHentec Industries/RPS Automation, a leading manufacturer of selective soldering, lead tinning and solderability test equipment, announces that it has published a technical paper describing the critical process parameters that need to be optimized to ensure optimal results and guarantee the utmost in end-product quality.