EIPC to Hold Board of Directors Election and General Assembly Meeting at productronica 2017


Reading time ( words)

The EIPC General Assembly meeting will take place on November 16, during productronica 2017 in Munich, Germany. 

This year, EIPC also needs to elect a Board of Directors for the period 2018-2019. The outcome of the election will be presented at the General Assembly meeting and by email after the meeting. EIPC has always been very well served by an excellent team of directors, who give generously of their time and expertise to assist the Institute in its work and without whom we would be greatly impoverished. 

The voting procedure is as follows:

1. A maximum of 10 candidates can be voted for. Please note if more than 10 votes are marked on the election form, the form will not be valid.

2. Please give your vote by ticking the corresponding box.

3. If you wish to add additional candidates to the list please indicate it on the form using the space under 'New EIPC Board member. The maximum number of candidates has to remain 10.

4. In addition to the 10 candidates for the Board, please give your vote for the treasurer on the bottom of the election form.

5. Please return your voting form by email to kwestenberg@eipc.org.

Share


Suggested Items

Book Recommendation: The Age of Agile—How Smart Companies are Transforming the Way Work Gets Done

07/26/2018 | Dan Beaulieu
This new book by Stephen Denning addresses the issue of change and adaptability like no other book I have read thus far…and I read a lot of business books! Centering on meeting the challenges of new and often changing business environments and how to meet them, the author’s focus on agility runs from the power of smaller teams that are focused on solving problems quickly while eschewing the normal bureaucratic road blocks that have been in place for decades.

Flex Time: Why is Rigid-Flex So Expensive?

07/11/2018 | Bob Burns, PRINTED CIRCUITS
One question that I hear fairly often, particularly after an initial quotation, is “Why is rigid-flex so expensive?” In this article, I’ll share with designers the cost drivers in rigid-flex relative to standard rigid boards and flex circuits with stiffeners. A typical rigid-flex PWB will cost about seven times the cost of the same design on a hard board, and two to three times an equivalent flex circuit with stiffeners.

Book Recommendation: Customer Service Training 101

07/06/2018 | Dan Beaulieu
No matter what business you are in, whether it be retail or B2B, you’re going to be able to benefit from everything in this book. It is without a doubt the best customer service training book on the market today.



Copyright © 2018 I-Connect007. All rights reserved.