Efficient Light Conversion with Perovskite Nanocrystals
October 12, 2018 | University of AmsterdamEstimated reading time: 3 minutes
Perovskites are a family of crystals that show promising properties for applications in nano-technology. However, one useful property that until now was unobserved in perovskites is so-called carrier multiplication—an effect that makes materials much more efficient in converting light into electricity. New research, led by UvA-IoP physicists Dr Chris de Weerd and Dr Leyre Gomez from the group of Prof. Tom Gregorkiewicz, has now shown that certain perovskites in fact do have this desirable property.
Crystals are configurations of atoms, molecules or ions, that are ordered in a structure that repeats itself in all directions. We have all encountered some crystals in everyday life: ordinary salt, diamond and even snowflakes are examples. What is perhaps less well-known is that certain crystals show very interesting properties when their size is not that of our everyday life but that of nanometers—a few billionths of a meter. There, we enter the world of nanocrystals, structures that have shown to be extremely useful in constructing technological applications at tiny scales.
Perovskites—named after 19th century Russian mineralogist Lev Perovski—form a particular family of materials that all share the same crystal structure. These perovskites have many desirable electronic properties, making them useful for constructing for example LEDs, TV-screens, solar cells and lasers. For this reason, the perovskites have been studied extensively by physicists in the past years.
Carrier Multiplication
A property which so far had not been shown to exist in perovskites is carrier multiplication. When semiconductors—in solar cells, for example—convert the energy of light into electricity, this is usually done one particle at a time: a single infalling photon results in a single excited electron (and the corresponding ‘hole’ where the electron used to be) that can carry an electrical current. However, in certain materials, if the infalling light is energetic enough, further electron-hole pairs can be excited as a result; it is this process that is known as carrier multiplication.
When carrier multiplication occurs, the conversion from light into electricity can become much more efficient. For example, in ordinary solar cells there is a theoretical limit (the so-called Shockley-Queisser limit) on the amount of energy that can be converted in this way: at most a little over 33% of the solar power gets turned into electrical power. In semiconductor nanocrystals that feature the carrier multiplication effect, however, a maximum efficiency of up to 44% is predicted.
PhD
This makes it very interesting to search for the carrier multiplication effect in perovskites as well, and that is precisely what UvA-IoP physicists Chris de Weerd and Leyre Gomez from the Optoelectronic Materials group led by Prof. Tom Gregorkiewicz, in collaboration with the group of Prof. Yasufumi Fujiwara and with support of their colleagues from the AIST National Institute in Tsukuba and the Delft University of Technology have now done. Using spectroscopy methods—studying the frequencies of the radiation that comes from a material after very briefly illuminating it with a flash of light—the researchers showed that perovskite nanocrystals made out of cesium, lead and iodine, do indeed display carrier multiplication. Moreover, they argue that the efficiency of this effect is higher than reported thus far for any other materials; with this finding therefore, the extraordinary properties of perovskites receive a new boost.
De Weerd, who successfully defended her PhD thesis based on this and other research last week, says: “Until now, carrier multiplication had not been reported for perovskites. That we have now found it is of great fundamental impact on this upcoming material. For example, this shows that perovskite nanocrystals can be used to construct very efficient photodetectors, and in the future perhaps solar cells.”
Suggested Items
Indium Corporation, Industry Partners to Showcase Products “Live@APEX”
03/26/2024 | Indium CorporationIndium Corporation®, in cooperation with its industry partners, will feature its proven solder solutions live on the show floor throughout IPC APEX Expo from Apr. 9‒11 in Anaheim, Calif., U.S.
Dymax Will Exhibit Light-Cure Solutions for Today’s Electronics at IPC APEX 2024
03/26/2024 | DymaxDymax, a leading manufacturer of rapid and light-curing materials and equipment, will exhibit at the IPC APEX EXPO 2024 in Anaheim, CA, April 9-11.
Ventec to Launch New Bondply Dielectrics and Value-Added Services at IPC APEX EXPO 2024
03/26/2024 | Ventec International GroupVentec International Group is to reveal new products for advanced signal integrity and thermal performance, and introduce services, during IPC APEX EXPO 2024, April 9-11 on booth # 4309.
Electra Polymers Ltd Expands Manufacturing Capacity, Invests in New Facilities and Talent
03/26/2024 | Electra Polymers LtdElectra Polymers Ltd, a leading provider of coatings for the electronics industry, proudly announces a significant expansion of its manufacturing capacity for inkjet materials. The company is making substantial investments in new facilities, talent acquisition, and cutting-edge laboratory equipment to meet the increasing demand for high-performance functional inkjet materials in the market.
I-Connect007 Editor’s Choice: Five Must-Reads for the Week
03/22/2024 | Nolan Johnson, I-Connect007This week's news feed contains a bunch of big money items, as well as some interesting industrial and technology puzzles to be solved. There’s even some down-home people news from the Dallas SMTA conference held this week. Don’t overlook the latest issue of PCB007 Magazine, either. The topic is sustainability, which is becoming an ecosystem of its own.