Henkel Advances Fan-In and Fan-Out Wafer-Level Packaging


Reading time ( words)

Henkel Corporation announced the commercial availability of LOCTITE ECCOBOND LCM 1000AF, a breakthrough encapsulation material that leverages a unique anhydride-free resin platform to enable thorough protection, improved warpage control and fine gap filling for fan-in and fan-out wafer-level packages (FI WLPs, FO WLPs). LOCTITE ECCOBOND LCM 1000AF, which is REACH-compliant, has shown effective reliability-enhancing performance in internal evaluations of several wafer-level packaging configurations including FI WLPs, embedded wafer-level ball grid arrays (eWLBs), FO WLPs, and chip-on-wafer (CoW) encapsulation.

As chip integration and new packaging technologies gain steam to address the cost, form factor and functional realities of accelerated electronics miniaturization, FO WLP and FI WLP approaches are increasingly being adopted, particularly for applications such as data processors, mobile devices, consumer electronics, and radio-frequency communication chipsets.  However, with thinner dies – some as thin as 50 µm or less –conventional anhydride-based molding materials may not meet today’s challenging requirements.

Henkel’s Global Market Segment Head for Semiconductor Packaging Materials, Ramachandran (“Ram”) Trichur, explains that traditional liquid compression molding materials are built on anhydride resin systems with larger filler sizes, which can limit warpage control effectiveness in FO WLP processes and the ability to penetrate narrow gaps for trench filling with FI WLP techniques. “The powder-type fillers often used in older-generation standard wafer encapsulation systems have large particle sizes that range from 25 µm to an upper cut of 50 µm,” he says, noting that some of the trenches between dies in FI WLP processes are as thin as 40 µm wide. “Standard encapsulants are challenged to thoroughly fill high-density structures and, during fan-out wafer-level processing, have also shown warpage of greater than 2.0 mm after molding, both factors that can impact long-term reliability and wafer handling.  Henkel’s anhydride-free epoxy liquid compression molding material resolves these issues.”   

LOCTITE ECCOBOND LCM 1000AF is a solvent-free encapsulant that integrates exceptionally fine particle fillers (average 3 µm, upper cut 10 µm), enabling high-yield, ultra-low warpage, excellent flow properties for void-free fine-dimension filling, and fast in-mold cure times for improved UPH. 

Share

Print


Suggested Items

Kirigami Inspires New Method for Wearable Sensors

10/22/2019 | University of Illinois
As wearable sensors become more prevalent, the need for a material resistant to damage from the stress and strains of the human body’s natural movement becomes ever more crucial. To that end, researchers at the University of Illinois at Urbana-Champaign have developed a method of adopting kirigami architectures to help materials become more strain tolerant and more adaptable to movement.

Brittle Pals Bond for Flexible Electronics

05/13/2019 | Rice University
Mixing two brittle materials to make something flexible defies common sense, but Rice University scientists have done just that to make a novel dielectric. Dielectrics are the polarized insulators in batteries and other devices that separate positive and negative electrodes. Without them, there are no electronic devices.

Beyond Scaling: An Electronics Resurgence Initiative

06/05/2017 | DARPA
The Department of Defense’s proposed FY 2018 budget includes a $75 million allocation for DARPA in support of a new, public-private “electronics resurgence” initiative. The initiative seeks to undergird a new era of electronics in which advances in performance will be catalyzed not just by continued component miniaturization but also by radically new microsystem materials, designs, and architectures.



Copyright © 2020 I-Connect007. All rights reserved.